Mirrors, blind spots and being seen
Set the interior mirror so its centre shows the centre of the rear window. For the left mirror, lean toward your window; for the right mirror, lean toward the middle of the car. Then angle each one until the rear of your own car just shows at its edge.
A mirror set up wrong hides exactly the traffic a driver most needs to see before changing position.
Glance at your mirrors about every five seconds as you drive, not only before a lane change. Mirrors still don't show everything beside your car, so before changing lanes or turning, also do a shoulder check, turning your head to glance over your shoulder, and give extra room to large commercial vehicles, which have large blind spots.
Even well-adjusted mirrors leave a gap beside the car that only turning your head can cover, and traffic around you keeps changing while you drive.
Dip to low beams once an oncoming vehicle is within 150 metres, and when following another vehicle within 60 metres, except while passing it. In fog or blowing snow, use low beams, since high beams reflect off the moisture or ice and make it harder to see.
High beams light more of the road but dazzle other drivers, so the law sets when you must dip them.
Signal before you slow down, stop, turn, change lanes, pull off the road or pull out from the curb, and do it well before you act. Then check that it's clear, because a signal alone doesn't make a move safe.
A signal only helps other drivers if it gives them time to react, not just notice your move as it happens.
Source: Official MTO Driver's Handbook, Driving along.
Check yourself with practice questions and mock tests. Try it free in your browser.